In general, we are capable to do FEED and/or detailed engineering for any chemical process industry similar to those specified in this section. For open art units, we can do FEED as well as detailed engineering independently whereas for licensed units, we can do detailed engineering based on the licensor’s BEP. We also have the capability to carry out pre-FID (pre-final investment decision) activities for such industries such as concept study, cost estimation study, techno-economic feasibility study.

Our capability to carry out design/engineering of any chemical process industry is underpinned by our following proven in-house engineering tools (MS Excel based calculation programs).

• Control valve hydraulics & Cv calculation
• Expansion tank sizing
• Heat release curve for multi-component condensation
• Flare header sizing
• Scrubber (gas-liquid absorber) design
• Flue gas stack sizing
• Heat exchanger (shell and tube exchanger, air-cooled exchanger, plate type exchanger) thermal design and rating
• Design of TEG Gas Dehydration System
• Design of multiple effect evaporation system (MEE) with or without vapor recompression and under vacuum or pressure operation
• Design of fuel combustion system and waste heat recovery system
• Orifice sizing calculations
• PSV relief load and sizing calculation
• Line hydraulics
• Pump hydraulics and sizing
• Compressor hydraulics and sizing including power & discharge temperature estimation
• Separator (two-phase & three-phase) sizing
• Tank sprinkler cooling system design
• Gas turbine, steam turbine and combined cycle calculations
• Design of water bath heater
• Pressure vessel thickness calculation
• Pipe thickness calculation